M100-DA1
| M100-DA1 | DC Current input 4kV isolation |
| M100-DV1 | DC Voltage 20mV to 11.9V input 4kV isolation |
| M100-DV2 | DC Voltage 12V to 600V input 4kV isolation |
| M100-DA1I | DC Current input 1.5kV isolation |
| M100-DV1I | DC Voltage 20mV to 11.9V input 1.5kV isolation |
| M100-DV2I | DC Voltage 12V to 600V input 1.5kV isolation |
| Typical Applications電話(huà)：029-85230751，84037291，85237916 |
| These isolators isolate the DC Input signal from the DC Output signal, which is directly proportional to the input signal. There are two levels of isolation offered, the M100-DA1/DV1/DV2 have 4kV isolation and the M100-DA1I/DV1I/DV2I have 1.5kV isolation. A wide range of both D.C. Current and voltage inputs are offered. Typically these isolators can be used to prevent earth loops which occur when a measuring source that is earthed, is connected to a computer or data logger that is also earthed. Another common use is to provide isolation on the inputs to a PLC. All of these isolators have either A.C. or D.C. auxiliaries which means that they have an advantage over loop powered units, in that if for any reason the output lead should become disconnected, the input will not be saturated. |
| INPUT | |
| Rated value In (range) | ±1mA to 10A M100-DA1/DA1I |
| Voltage drop | 20mV |
| Ranges rated value Un | 0 to ±20mV to 0 to 11.9V M100-DV1/DV1I |
| Impedance | 10 kohm/volt |
| Working Range | ±125% In |
| Overload continuous | 4 x In M100-DA1 (up to 20A max) |
| Overload continuous | 1.5 x Un M100-DV1/DV2 |
| OUTPUT | |
| Rated value mA | 0-1/0-5/0-10/0-20mA & 4-20mA |
| Load Resistance | 12/2.4/1.2/0.6 kOhm |
| Rated value volts | 0-5/0-10V & 1-5V |
| ADJUSTMENT | |
| Zero | ±2% |
| Span | ±10% |
| AUXILIARY | |
| A.C.Voltage | 115/230/400V (±25% 45-65Hz / 2VA |
| | |
| D.C. Voltage | 24/48/110V (±20% / galvanically isolated / <3W) |
| | |
| WEIGHT & CASE SIZE | Approx 0.4kg. 55mm case |
| INSULATION | |
| M100-DA1/DV1/DV2 | 4kV as shown in general |
| | specification pages. |
| M100-DA1I/DV1I/DV2I | Test voltage 1.5kV RMS 50Hz |
| | 1 min between input/case/output, |
| | rest of spec as shown in general |
| | specification page. |
| Product Code | Input In | Output | Aux | Freq | Options |
| M100-DA1I | 1mA | 4-20mA | 230v | 50Hz | |
| 1 | Non standard Inputs/Outputs as far as technically viable |
| 2 | A.C. Auxiliary in range 57.7 to 450 volts |
| 3 | Calibration at temperature other than 23ºC |